Instructions for use THERMOWHITE insulation fill

1. Delivery and Storage

• When working with bagged goods, use only unopened original containers (bags/big bags) from Thermowhite.
• Store the containers protected from the weather (rain, wind, direct sunlight).
• Avoid damaging the bags. If a bag tears, sweep up the material immediately and dispose of it properly or use it immediately.

2. Mixing and Preparation

• The Thermowhite EPS granulate must be mixed with the Thermowhite binding agent and water on site in closed mixers or in mixing containers designed for this purpose.
• Avoid loose pouring or shoveling of the EPS beads to prevent them from blowing away.
• It is essential to strictly adhere to the manufacturer's specifications for binder addition and water quantity to ensure complete coating of the EPS particles (< 5 mm). The material must be solid when dry.
• Observe the specified mixing time to ensure homogeneous and complete bonding of each EPS grain.

3. Installation and Processing

• The mixed fill should be transported to the installation site with as little dust as possible (e.g., by pumping with a closed mobile mixing plant or in designated mixing containers).
• In case of rain, immediately after installation of the fill outdoors (pool, flat roof), the fill must be covered with a protective layer (for example PE film, tarpaulin, etc.) to prevent loose EPS particles (< 5 mm) from being washed away or blown away.
• Work in low wind conditions; in windy conditions, protective measures (e.g., temporary enclosures, tarpaulins) must be taken to prevent particles from being blown away.

4. Cleaning and Disposal

• Keep the construction site and mixing areas clean at all times. Sweep up any residue with a damp broom to prevent small particles from being stirred up.
• Collect all waste, especially EPS granulate or residues of unbound fill, and dispose of it properly (residual waste or hazardous waste in accordance with local regulations).
• Clean tools and mixers over a collection container to prevent rinse water containing EPS particles (< 5 mm) from entering the environment.
• After completing the work, thoroughly check the area for any remaining particles.